My Book "Practical Microstrip and Printed Antenna Design" is published now!!!


My Book "Practical Microstrip and Printed Antenna Design" is published now and available for sale. With all of the functionality now integrated into wireless devices, antenna design and development are taking more and more time. But a reliable design process with the right capabilities, like phased array beamforming, antenna beam shaping, can help you improve design throughput and reduce cost.


Review the fundamental specifications of practical microstrip and printed antennas design and see what capabilities you should consider getting the right technique for your design. 
  1. https://us.artechhouse.com/Practical-Microstrip-and-Printed-Antenna-Design-P2002.aspx
  2. https://www.amazon.com/Practical-Microstrip-Printed-Antenna-Design/dp/163081668X

Practical Microstrip and Printed Antenna Design
Practical Microstrip and Printed Antenna Design

Comments

Post a Comment

Popular posts from this blog

Image
Slotted Waveguide Array Antenna Slotted antenna arrays used with waveguides are a popular antenna in navigation, radar, and other high-frequency systems. A waveguide is a very low loss transmission line. It allows propagating signals to a number of smaller antennas (slots). Each of these slots allows a little of the energy to radiate. Slot impedance and resonant behavior for a single slot are dependent on slot placement and size. Its exceptional directivity in the elevation plane gives it quite high power gain. The slotted waveguide has achieved most of its success when used in an omnidirectional role To make the unidirectional antenna radiate over the entire 360 degrees of azimuth, the second set of slots are cut on the back face of the waveguide. An 8×8 planar four pole X-band Tchebyshev dual inductive post substrate integrated waveguide filter from 10.15 GHz to 10.7 GHz is designed for terrestrial broadcasting. The filter is designed on the 5870 with a relative dielectric...
Read more

EMI & EMC Compliance of Smartphone

EMC within electronic components has become an increasingly important issue for embedded designers to contend with. As system frequencies and the need for lower supply voltages increase, the end application becomes more and more vulnerable to the negative affects of EMI. These electrical influences can be generated by either radiated or conductive EMI sources. Radiated sources include anything electrical or electromechanical, including motors, power lines, antennas, traces on a PCB (Printed Circuit Board), and even the silicon components on the PCB. Conductive EMI primarily shows itself as electrical “noise” on the power supply lines of an application and can be caused by induced voltage spikes from other devices within a system. Electromagnetic Interference (EMI): Electromagnetic emissions from a device or system that  interfere with the normal operation of another device or system. EMI is also referred to as Radio Frequency Interference (RFI) Electromagnetic Compatibilit...
Read more

QFN Package Simulation

Image
he Quad Flat No-lead (QFN) package is a CSP (plastic encapsulated package) with a copper lead frame substrate. QFN type package is one of the most cutting-edge IC packaging technologies in the electronics. The QFN is a leadless package where electrical contact to the PCB is made by soldering the leads on the bottom surface of the package to the PCB, instead of the conventional formed perimeter gull wing leads. The QFN-type package is known for its small size, cost-effectiveness and good production yields. QFN also possess certain mechanical advantages for high-speed circuits including improved co-planarity and heat dissipation. The QFN has pins on 4 edges of the bottom surface of the package. The QFN can have either a square or rectangle body as well as symmetric or asymmetric terminal patterns. The QFN was introduced to replace the gull wing lead Quad Flat Package (QFP) because the component leads are embedded in the plastic and cannot be bent during handling to insure consistent ...
Read more